kernel/drivers/net/dsa/mv88e6060.h
2024-07-22 17:22:30 +08:00

120 lines
4.2 KiB
C

/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* drivers/net/dsa/mv88e6060.h - Marvell 88e6060 switch chip support
* Copyright (c) 2015 Neil Armstrong
*
* Based on mv88e6xxx.h
* Copyright (c) 2008 Marvell Semiconductor
*/
#ifndef __MV88E6060_H
#define __MV88E6060_H
#define MV88E6060_PORTS 6
#define REG_PORT(p) (0x8 + (p))
#define PORT_STATUS 0x00
#define PORT_STATUS_PAUSE_EN BIT(15)
#define PORT_STATUS_MY_PAUSE BIT(14)
#define PORT_STATUS_FC (PORT_STATUS_MY_PAUSE | PORT_STATUS_PAUSE_EN)
#define PORT_STATUS_RESOLVED BIT(13)
#define PORT_STATUS_LINK BIT(12)
#define PORT_STATUS_PORTMODE BIT(11)
#define PORT_STATUS_PHYMODE BIT(10)
#define PORT_STATUS_DUPLEX BIT(9)
#define PORT_STATUS_SPEED BIT(8)
#define PORT_SWITCH_ID 0x03
#define PORT_SWITCH_ID_6060 0x0600
#define PORT_SWITCH_ID_6060_MASK 0xfff0
#define PORT_SWITCH_ID_6060_R1 0x0601
#define PORT_SWITCH_ID_6060_R2 0x0602
#define PORT_CONTROL 0x04
#define PORT_CONTROL_FORCE_FLOW_CTRL BIT(15)
#define PORT_CONTROL_TRAILER BIT(14)
#define PORT_CONTROL_HEADER BIT(11)
#define PORT_CONTROL_INGRESS_MODE BIT(8)
#define PORT_CONTROL_VLAN_TUNNEL BIT(7)
#define PORT_CONTROL_STATE_MASK 0x03
#define PORT_CONTROL_STATE_DISABLED 0x00
#define PORT_CONTROL_STATE_BLOCKING 0x01
#define PORT_CONTROL_STATE_LEARNING 0x02
#define PORT_CONTROL_STATE_FORWARDING 0x03
#define PORT_VLAN_MAP 0x06
#define PORT_VLAN_MAP_DBNUM_SHIFT 12
#define PORT_VLAN_MAP_TABLE_MASK 0x1f
#define PORT_ASSOC_VECTOR 0x0b
#define PORT_ASSOC_VECTOR_MONITOR BIT(15)
#define PORT_ASSOC_VECTOR_PAV_MASK 0x1f
#define PORT_RX_CNTR 0x10
#define PORT_TX_CNTR 0x11
#define REG_GLOBAL 0x0f
#define GLOBAL_STATUS 0x00
#define GLOBAL_STATUS_SW_MODE_MASK (0x3 << 12)
#define GLOBAL_STATUS_SW_MODE_0 (0x0 << 12)
#define GLOBAL_STATUS_SW_MODE_1 (0x1 << 12)
#define GLOBAL_STATUS_SW_MODE_2 (0x2 << 12)
#define GLOBAL_STATUS_SW_MODE_3 (0x3 << 12)
#define GLOBAL_STATUS_INIT_READY BIT(11)
#define GLOBAL_STATUS_ATU_FULL BIT(3)
#define GLOBAL_STATUS_ATU_DONE BIT(2)
#define GLOBAL_STATUS_PHY_INT BIT(1)
#define GLOBAL_STATUS_EEINT BIT(0)
#define GLOBAL_MAC_01 0x01
#define GLOBAL_MAC_01_DIFF_ADDR BIT(8)
#define GLOBAL_MAC_23 0x02
#define GLOBAL_MAC_45 0x03
#define GLOBAL_CONTROL 0x04
#define GLOBAL_CONTROL_DISCARD_EXCESS BIT(13)
#define GLOBAL_CONTROL_MAX_FRAME_1536 BIT(10)
#define GLOBAL_CONTROL_RELOAD_EEPROM BIT(9)
#define GLOBAL_CONTROL_CTRMODE BIT(8)
#define GLOBAL_CONTROL_ATU_FULL_EN BIT(3)
#define GLOBAL_CONTROL_ATU_DONE_EN BIT(2)
#define GLOBAL_CONTROL_PHYINT_EN BIT(1)
#define GLOBAL_CONTROL_EEPROM_DONE_EN BIT(0)
#define GLOBAL_ATU_CONTROL 0x0a
#define GLOBAL_ATU_CONTROL_SWRESET BIT(15)
#define GLOBAL_ATU_CONTROL_LEARNDIS BIT(14)
#define GLOBAL_ATU_CONTROL_ATUSIZE_256 (0x0 << 12)
#define GLOBAL_ATU_CONTROL_ATUSIZE_512 (0x1 << 12)
#define GLOBAL_ATU_CONTROL_ATUSIZE_1024 (0x2 << 12)
#define GLOBAL_ATU_CONTROL_ATE_AGE_SHIFT 4
#define GLOBAL_ATU_CONTROL_ATE_AGE_MASK (0xff << 4)
#define GLOBAL_ATU_CONTROL_ATE_AGE_5MIN (0x13 << 4)
#define GLOBAL_ATU_OP 0x0b
#define GLOBAL_ATU_OP_BUSY BIT(15)
#define GLOBAL_ATU_OP_NOP (0 << 12)
#define GLOBAL_ATU_OP_FLUSH_ALL ((1 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_OP_FLUSH_UNLOCKED ((2 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_OP_LOAD_DB ((3 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_OP_GET_NEXT_DB ((4 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_OP_FLUSH_DB ((5 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_OP_FLUSH_UNLOCKED_DB ((6 << 12) | GLOBAL_ATU_OP_BUSY)
#define GLOBAL_ATU_DATA 0x0c
#define GLOBAL_ATU_DATA_PORT_VECTOR_MASK 0x3f0
#define GLOBAL_ATU_DATA_PORT_VECTOR_SHIFT 4
#define GLOBAL_ATU_DATA_STATE_MASK 0x0f
#define GLOBAL_ATU_DATA_STATE_UNUSED 0x00
#define GLOBAL_ATU_DATA_STATE_UC_STATIC 0x0e
#define GLOBAL_ATU_DATA_STATE_UC_LOCKED 0x0f
#define GLOBAL_ATU_DATA_STATE_MC_STATIC 0x07
#define GLOBAL_ATU_DATA_STATE_MC_LOCKED 0x0e
#define GLOBAL_ATU_MAC_01 0x0d
#define GLOBAL_ATU_MAC_23 0x0e
#define GLOBAL_ATU_MAC_45 0x0f
struct mv88e6060_priv {
/* MDIO bus and address on bus to use. When in single chip
* mode, address is 0, and the switch uses multiple addresses
* on the bus. When in multi-chip mode, the switch uses a
* single address which contains two registers used for
* indirect access to more registers.
*/
struct mii_bus *bus;
int sw_addr;
struct dsa_switch *ds;
};
#endif