62 lines
2.1 KiB
Plaintext
62 lines
2.1 KiB
Plaintext
Broadcom BCM7038-style Level 1 interrupt controller
|
|
|
|
This block is a first level interrupt controller that is typically connected
|
|
directly to one of the HW INT lines on each CPU. Every BCM7xxx set-top chip
|
|
since BCM7038 has contained this hardware.
|
|
|
|
Key elements of the hardware design include:
|
|
|
|
- 64, 96, 128, or 160 incoming level IRQ lines
|
|
|
|
- Most onchip peripherals are wired directly to an L1 input
|
|
|
|
- A separate instance of the register set for each CPU, allowing individual
|
|
peripheral IRQs to be routed to any CPU
|
|
|
|
- Atomic mask/unmask operations
|
|
|
|
- No polarity/level/edge settings
|
|
|
|
- No FIFO or priority encoder logic; software is expected to read all
|
|
2-5 status words to determine which IRQs are pending
|
|
|
|
Required properties:
|
|
|
|
- compatible: should be "brcm,bcm7038-l1-intc"
|
|
- reg: specifies the base physical address and size of the registers;
|
|
the number of supported IRQs is inferred from the size argument
|
|
- interrupt-controller: identifies the node as an interrupt controller
|
|
- #interrupt-cells: specifies the number of cells needed to encode an interrupt
|
|
source, should be 1.
|
|
- interrupts: specifies the interrupt line(s) in the interrupt-parent controller
|
|
node; valid values depend on the type of parent interrupt controller
|
|
|
|
Optional properties:
|
|
|
|
- brcm,irq-can-wake: If present, this means the L1 controller can be used as a
|
|
wakeup source for system suspend/resume.
|
|
|
|
Optional properties:
|
|
|
|
- brcm,int-fwd-mask: if present, a bit mask to indicate which interrupts
|
|
have already been configured by the firmware and should be left unmanaged.
|
|
This should have one 32-bit word per status/set/clear/mask group.
|
|
|
|
If multiple reg ranges and interrupt-parent entries are present on an SMP
|
|
system, the driver will allow IRQ SMP affinity to be set up through the
|
|
/proc/irq/ interface. In the simplest possible configuration, only one
|
|
reg range and one interrupt-parent is needed.
|
|
|
|
Example:
|
|
|
|
periph_intc: periph_intc@1041a400 {
|
|
compatible = "brcm,bcm7038-l1-intc";
|
|
reg = <0x1041a400 0x30 0x1041a600 0x30>;
|
|
|
|
interrupt-controller;
|
|
#interrupt-cells = <1>;
|
|
|
|
interrupt-parent = <&cpu_intc>;
|
|
interrupts = <2>, <3>;
|
|
};
|