55 lines
1.7 KiB
Plaintext
55 lines
1.7 KiB
Plaintext
Texas Instruments INA3221 Device Tree Bindings
|
|
|
|
1) ina3221 node
|
|
Required properties:
|
|
- compatible: Must be "ti,ina3221"
|
|
- reg: I2C address
|
|
|
|
Optional properties:
|
|
- ti,single-shot: This chip has two power modes: single-shot (chip takes one
|
|
measurement and then shuts itself down) and continuous (
|
|
chip takes continuous measurements). The continuous mode is
|
|
more reliable and suitable for hardware monitor type device,
|
|
but the single-shot mode is more power-friendly and useful
|
|
for battery-powered device which cares power consumptions
|
|
while still needs some measurements occasionally.
|
|
If this property is present, the single-shot mode will be
|
|
used, instead of the default continuous one for monitoring.
|
|
|
|
= The node contains optional child nodes for three channels =
|
|
= Each child node describes the information of input source =
|
|
|
|
- #address-cells: Required only if a child node is present. Must be 1.
|
|
- #size-cells: Required only if a child node is present. Must be 0.
|
|
|
|
2) child nodes
|
|
Required properties:
|
|
- reg: Must be 0, 1 or 2, corresponding to IN1, IN2 or IN3 port of INA3221
|
|
|
|
Optional properties:
|
|
- label: Name of the input source
|
|
- shunt-resistor-micro-ohms: Shunt resistor value in micro-Ohm
|
|
|
|
Example:
|
|
|
|
ina3221@40 {
|
|
compatible = "ti,ina3221";
|
|
reg = <0x40>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
|
|
input@0 {
|
|
reg = <0x0>;
|
|
status = "disabled";
|
|
};
|
|
input@1 {
|
|
reg = <0x1>;
|
|
shunt-resistor-micro-ohms = <5000>;
|
|
};
|
|
input@2 {
|
|
reg = <0x2>;
|
|
label = "VDD_5V";
|
|
shunt-resistor-micro-ohms = <5000>;
|
|
};
|
|
};
|