203 lines
4.4 KiB
C
203 lines
4.4 KiB
C
|
// SPDX-License-Identifier: GPL-2.0-or-later
|
||
|
/*
|
||
|
* linux/arch/arm/mach-integrator/integrator_ap.c
|
||
|
*
|
||
|
* Copyright (C) 2000-2003 Deep Blue Solutions Ltd
|
||
|
*/
|
||
|
#include <linux/kernel.h>
|
||
|
#include <linux/init.h>
|
||
|
#include <linux/syscore_ops.h>
|
||
|
#include <linux/amba/bus.h>
|
||
|
#include <linux/io.h>
|
||
|
#include <linux/irqchip.h>
|
||
|
#include <linux/of_irq.h>
|
||
|
#include <linux/of_address.h>
|
||
|
#include <linux/of_platform.h>
|
||
|
#include <linux/termios.h>
|
||
|
#include <linux/mfd/syscon.h>
|
||
|
#include <linux/regmap.h>
|
||
|
|
||
|
#include <asm/mach/arch.h>
|
||
|
#include <asm/mach/map.h>
|
||
|
|
||
|
#include "hardware.h"
|
||
|
#include "cm.h"
|
||
|
#include "common.h"
|
||
|
|
||
|
/* Regmap to the AP system controller */
|
||
|
static struct regmap *ap_syscon_map;
|
||
|
|
||
|
/*
|
||
|
* All IO addresses are mapped onto VA 0xFFFx.xxxx, where x.xxxx
|
||
|
* is the (PA >> 12).
|
||
|
*
|
||
|
* Setup a VA for the Integrator interrupt controller (for header #0,
|
||
|
* just for now).
|
||
|
*/
|
||
|
#define VA_IC_BASE __io_address(INTEGRATOR_IC_BASE)
|
||
|
|
||
|
/*
|
||
|
* Logical Physical
|
||
|
* f1400000 14000000 Interrupt controller
|
||
|
* f1600000 16000000 UART 0
|
||
|
*/
|
||
|
|
||
|
static struct map_desc ap_io_desc[] __initdata __maybe_unused = {
|
||
|
{
|
||
|
.virtual = IO_ADDRESS(INTEGRATOR_IC_BASE),
|
||
|
.pfn = __phys_to_pfn(INTEGRATOR_IC_BASE),
|
||
|
.length = SZ_4K,
|
||
|
.type = MT_DEVICE
|
||
|
}, {
|
||
|
.virtual = IO_ADDRESS(INTEGRATOR_UART0_BASE),
|
||
|
.pfn = __phys_to_pfn(INTEGRATOR_UART0_BASE),
|
||
|
.length = SZ_4K,
|
||
|
.type = MT_DEVICE
|
||
|
}
|
||
|
};
|
||
|
|
||
|
static void __init ap_map_io(void)
|
||
|
{
|
||
|
iotable_init(ap_io_desc, ARRAY_SIZE(ap_io_desc));
|
||
|
}
|
||
|
|
||
|
#ifdef CONFIG_PM
|
||
|
static unsigned long ic_irq_enable;
|
||
|
|
||
|
static int irq_suspend(void)
|
||
|
{
|
||
|
ic_irq_enable = readl(VA_IC_BASE + IRQ_ENABLE);
|
||
|
return 0;
|
||
|
}
|
||
|
|
||
|
static void irq_resume(void)
|
||
|
{
|
||
|
/* disable all irq sources */
|
||
|
cm_clear_irqs();
|
||
|
writel(-1, VA_IC_BASE + IRQ_ENABLE_CLEAR);
|
||
|
writel(-1, VA_IC_BASE + FIQ_ENABLE_CLEAR);
|
||
|
|
||
|
writel(ic_irq_enable, VA_IC_BASE + IRQ_ENABLE_SET);
|
||
|
}
|
||
|
#else
|
||
|
#define irq_suspend NULL
|
||
|
#define irq_resume NULL
|
||
|
#endif
|
||
|
|
||
|
static struct syscore_ops irq_syscore_ops = {
|
||
|
.suspend = irq_suspend,
|
||
|
.resume = irq_resume,
|
||
|
};
|
||
|
|
||
|
static int __init irq_syscore_init(void)
|
||
|
{
|
||
|
register_syscore_ops(&irq_syscore_ops);
|
||
|
|
||
|
return 0;
|
||
|
}
|
||
|
|
||
|
device_initcall(irq_syscore_init);
|
||
|
|
||
|
/*
|
||
|
* For the PL010 found in the Integrator/AP some of the UART control is
|
||
|
* implemented in the system controller and accessed using a callback
|
||
|
* from the driver.
|
||
|
*/
|
||
|
static void integrator_uart_set_mctrl(struct amba_device *dev,
|
||
|
void __iomem *base, unsigned int mctrl)
|
||
|
{
|
||
|
unsigned int ctrls = 0, ctrlc = 0, rts_mask, dtr_mask;
|
||
|
u32 phybase = dev->res.start;
|
||
|
int ret;
|
||
|
|
||
|
if (phybase == INTEGRATOR_UART0_BASE) {
|
||
|
/* UART0 */
|
||
|
rts_mask = 1 << 4;
|
||
|
dtr_mask = 1 << 5;
|
||
|
} else {
|
||
|
/* UART1 */
|
||
|
rts_mask = 1 << 6;
|
||
|
dtr_mask = 1 << 7;
|
||
|
}
|
||
|
|
||
|
if (mctrl & TIOCM_RTS)
|
||
|
ctrlc |= rts_mask;
|
||
|
else
|
||
|
ctrls |= rts_mask;
|
||
|
|
||
|
if (mctrl & TIOCM_DTR)
|
||
|
ctrlc |= dtr_mask;
|
||
|
else
|
||
|
ctrls |= dtr_mask;
|
||
|
|
||
|
ret = regmap_write(ap_syscon_map,
|
||
|
INTEGRATOR_SC_CTRLS_OFFSET,
|
||
|
ctrls);
|
||
|
if (ret)
|
||
|
pr_err("MODEM: unable to write PL010 UART CTRLS\n");
|
||
|
|
||
|
ret = regmap_write(ap_syscon_map,
|
||
|
INTEGRATOR_SC_CTRLC_OFFSET,
|
||
|
ctrlc);
|
||
|
if (ret)
|
||
|
pr_err("MODEM: unable to write PL010 UART CRTLC\n");
|
||
|
}
|
||
|
|
||
|
struct amba_pl010_data ap_uart_data = {
|
||
|
.set_mctrl = integrator_uart_set_mctrl,
|
||
|
};
|
||
|
|
||
|
void __init ap_init_early(void)
|
||
|
{
|
||
|
}
|
||
|
|
||
|
static void __init ap_init_irq_of(void)
|
||
|
{
|
||
|
cm_init();
|
||
|
irqchip_init();
|
||
|
}
|
||
|
|
||
|
/* For the Device Tree, add in the UART callbacks as AUXDATA */
|
||
|
static struct of_dev_auxdata ap_auxdata_lookup[] __initdata = {
|
||
|
OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART0_BASE,
|
||
|
"uart0", &ap_uart_data),
|
||
|
OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART1_BASE,
|
||
|
"uart1", &ap_uart_data),
|
||
|
{ /* sentinel */ },
|
||
|
};
|
||
|
|
||
|
static const struct of_device_id ap_syscon_match[] = {
|
||
|
{ .compatible = "arm,integrator-ap-syscon"},
|
||
|
{ },
|
||
|
};
|
||
|
|
||
|
static void __init ap_init_of(void)
|
||
|
{
|
||
|
struct device_node *syscon;
|
||
|
|
||
|
of_platform_default_populate(NULL, ap_auxdata_lookup, NULL);
|
||
|
|
||
|
syscon = of_find_matching_node(NULL, ap_syscon_match);
|
||
|
if (!syscon)
|
||
|
return;
|
||
|
ap_syscon_map = syscon_node_to_regmap(syscon);
|
||
|
if (IS_ERR(ap_syscon_map)) {
|
||
|
pr_crit("could not find Integrator/AP system controller\n");
|
||
|
return;
|
||
|
}
|
||
|
}
|
||
|
|
||
|
static const char * ap_dt_board_compat[] = {
|
||
|
"arm,integrator-ap",
|
||
|
NULL,
|
||
|
};
|
||
|
|
||
|
DT_MACHINE_START(INTEGRATOR_AP_DT, "ARM Integrator/AP (Device Tree)")
|
||
|
.reserve = integrator_reserve,
|
||
|
.map_io = ap_map_io,
|
||
|
.init_early = ap_init_early,
|
||
|
.init_irq = ap_init_irq_of,
|
||
|
.init_machine = ap_init_of,
|
||
|
.dt_compat = ap_dt_board_compat,
|
||
|
MACHINE_END
|